Transferring the BATTERYGUARD to a new batteryīATTERYGUARD can easily be transferred to a new battery. Remote control to immobilize the engine by cutting off battery power, theīATTERYGUARD will now be ready to secure your vehicle.Īfter installation, please run a test using the operation manual.Īll vehicle settings dependent on battery power will need to be reset after Installation. At this stage theīATTERYGUARD can be used as a GUARD against battery drain or with the The installation of the BATTERYGUARD is now complete and the main unit will Pull off the double sided tape from the bottom of the Buzzer and attach it on toĪ secure place away from any moving parts or any heat source of the engine. (black or marked - ) of the BATTERYGUARD in the bolt assembly and tightenĮnsure the surface of the location is clean before attempting to mount it. ![]() Step 2, back to the negative post of the vehicle. Now return the negative cable of the car battery, which had been removed in Use the vehicle insulator cap to cover the connection for Please be sure to tighten the screw securely andĮnsure that the red plastic insulator cap (included) is installed over theīATTERYGUARD Instruction Manual of 5Ĭonnect side of the BATTERYGUARD marked “CABLE+” to positive power cableĪnd firmly attach it with the included Positive Post and screws. Positive post of the Vehicle Battery and firmly attach it with the included BatteryĬonnector and screws. Remove the positive cable (red or marked with +) from the battery post of theĬonnect the positive(+) side of the BATTERYGUARD marked “BATT+” to the Intended for your safety, to prevent any sparking during the installation. Remove the negative cable of your car battery. Open the Car hood (or any other access to the car battery). BG360RE/BG360)įollow these instructions closely for correct installation :Įnsure the ignition is turned off, and all other equipment, such as GPS and Otherwise apply a larger cooling plate.KingStart BatteryGuard (Model No. Please ensure that the maximum specified temperature (as specified in the module's description) is not exceeded. When the aluminum floor of the module curls up, the joints and the module start loosen and the module is defective. The reason: on the inside of the aluminum base of the module the thin insulating layer are directly soldered on the electronic SMD components. The screw heads must rest on the plate of the module, rather than on the plastic edge of the module! During assembly, the module should not be curled up (if the ground is not flat). The aluminum plate on the bottom of the module must not bend, do not use larger screws and do not drill larger holes. This may be the back wall of a metal casing. ![]() It is important that the module is fixed with 4 M3 screws (or 2.9mm metal screws) on the cooling surface. ![]() ![]() Under certain circumstances it must be mounted on a cooling surface according to installation instructions. The heat is dissipated from the aluminum plate at the bottom of the module. Important installation instructions, please note!ĭepending on the load the module heats up. The interrupting voltage is adjustable: approx. It switches on again automatically after return of the normal voltage. This battery saver protects your car battery from total discharge by switching off consumers such as ice boxes, heaters, radios + television sets, etc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |